The guidance view

The guidance view is used to guide you along the route to your destination. The guidance view is shown when you start driving. You see your current location and details along your route, including 3D buildings in some cities.

The guidance view is normally in 3D. To show a 2D map with the map moving in your direction of travel, change the 2D and 3D default settings.

Tip: When you have planned a route and the 3D guidance view is shown, select the switch view button to change to the map view and use the interactive features.

When the navigation app starts after it was turned off and you have a route planned, you are shown the map view with your planned route.

1. Switch view button. Select the switch view button to change between the map view and the guidance view.
2. Zoom buttons. Select the zoom buttons to zoom in and out.

   Tip: On most devices you can also pinch to zoom in and out.

3. Instruction panel. This panel shows the following information:
   • The direction of your next turn.
   • The distance to your next turn.
   • The name of the next road on your route.
   • Lane guidance at some junctions.
4. Route symbols. Symbols are used on your route to show your starting location, your stops (Adding a stop to your route from the current route menu, Adding a stop to your route using the map), and your destination.
5. Main Menu button. Select the button to show the Main Menu.
6. Speed panel. This panel shows the following information:
   • The speed limit at your location.
   • Your current speed. If you drive more than 5 km/h or 3 mph over the speed limit the speed panel turns red. If you drive less than 5 km/h or 3 mph over the speed limit the speed panel turns orange.
   • The name of the street you are driving on.
7. Current location. This symbol shows your current location.

   Note: If your Bridge cannot find your location using GPS or other methods, the symbol appears grey.

8. Route bar. The route bar is shown when you have planned a route.

   Important: To see a wider route bar showing additional route information, change the setting for Route Information.