Use the supplied mount to install your TomTom START in your vehicle. Read the instructions about positioning your device before you install your START.
To install your START, do the following:
Connect the supplied USB cable to the mount. If the mount is integrated into your START, connect the USB cable to the device.
Note: Use ONLY the USB cable supplied with your START. Other USB cables may not work.
Connect the USB cable to the USB car charger and plug this into the power supply on your dashboard.
Choose the best smooth location, on your windscreen or side window, to mount your TomTom START.
Tip: If the mount is integrated into your START, you can easily change the rotation of your device. Release the mount from the START using the thumb indent. Turn the mount around and clip it back onto the device until you hear it click.
Make sure that both the suction cup on the mount and your windscreen are clean and dry.
Press the suction cup of the mount firmly against your windscreen.
Turn the rubber grip near the base of the mount in a clockwise direction until you feel it lock.
If your mount is not integrated into your START, place your START in the mount, making sure that it clicks into place.
Dashboard adhesive disks are available as part of a range of accessories for your START. For more information, go to tomtom.com/accessories.