Importing routes from your computer using USB

You can import two types of files to your Rider from your computer using USB:

• GPX files - these become tracks after import.
• ITN files - these become routes after import.

  Tip: ITN files are TomTom itinerary files. Friends may share itinerary files with you or you can download both ITN and GPX files from Tyre Pro.

To import routes using USB, do the following:

1. Connect your Rider to your computer using the USB cable supplied, then switch your Rider on.

   The Connected to your computer screen is shown.

   Note: Use ONLY the USB cable supplied with your Rider. Other USB cables may not work.

   Note: You should plug the USB cable directly into a USB port on your computer and not into a USB hub or USB port on a keyboard or monitor.

   Tip: If you exit the connected to your computer screen but you still want to import routes, disconnect the USB cable from your computer then connect it again.

2. On your Rider, select Import Routes.
3. Open a file browser on your computer.

   Tip: Your Rider is shown as a computer drive.

4. In the file browser, copy the route or routes you want to import then paste them on to your Rider.

   Tip: You can paste your routes into the root directory or the Internal Storage folder. If you have a memory card in your Rider, you can also copy your routes to the SD Card folder.

5. On your Rider, select Done.

   Your Rider shows the routes you copied.

6. Select one or more routes to import, then select Import.

   You see the message Importing routes.

7. When you see the message Import Completed, select OK then disconnect your Rider.
8. To view your imported routes and tracks, select My Routes in the Main Menu.