Planning a route to an address

STEP-BY-STEP SEARCH ONLY

Important: In the interest of safety and to avoid distractions while you are driving, you should always plan a route before you start driving.

To plan a route to an address, do the following:

1. Select the Main Menu button to open the Main Menu.

   

2. Select Drive To.

   

3. Select Address.

   You can change the country or state setting by selecting the flag before you select a city.

4. Enter the town or city name, or the postal code.

   Towns with similar names are shown in the list while you type.

   When the correct city or town appears in the list, select the name.

   

5. Enter the street name.

   Streets with similar names are shown in the list while you type.

   When the correct street name appears in the list, select the name.

   

6. Enter the house number.

   Tip: If the house number does not exist then it appears red. The nearest house number is then shown in the Drive to button.

   

7. Select Drive/Ride, depending on which device you are using.

   A route is planned and then guidance to your destination begins. As soon as you start driving, the guidance view is shown automatically.

   Tip: If your destination is in a different time zone, you see a plus (+) or a minus (-) sign and the time difference in hours and half hours in the arrival information panel. The estimated time of arrival is the local time at your destination.

   Tip: You can add a stop to a route that you have already planned.

   Tip: You can save a route using My Routes.