Importing routes from your computer using USB

You can import two types of files to your TomTom Rider from your computer using USB:

• GPX files - these become tracks after import.
• ITN files - these become routes after import.

  Tip: ITN files are TomTom itinerary files.

To import routes using USB, do the following:

1. Connect your TomTom Rider to your computer using the USB cable supplied, then switch your TomTom Rider on.

   The Connected to your computer screen is shown.

   Note: Use ONLY the USB cable supplied with your TomTom Rider. Other USB cables may not work.

   Note: You should plug the USB cable directly into a USB port on your computer and not into a USB hub or USB port on a keyboard or monitor.

   Tip: If you exit the Connected to your computer screen but you still want to import routes, disconnect the USB cable from your computer then connect it again.

2. On your TomTom Rider, select Import Routes.
3. Open a file browser on your computer.

   Tip: Your TomTom Rider is shown as a computer drive.

4. In the file browser, copy the route or routes you want to import then paste them on to your TomTom Rider.

   Tip: You can paste your routes into the root directory or the Internal Storage folder. If you have a memory card in your TomTom Rider, you can also copy your routes to the SD Card folder.

5. On your TomTom Rider, select Done.

   Your TomTom Rider shows the routes you copied.

6. Select one or more routes to import, then select Import.

   You see the message Importing routes.

7. When you see the message Import Completed, select OK then disconnect your TomTom Rider.
8. To view your imported routes and tracks, select My Routes in the Main Menu.