Installing in your car

If your box contains a car mount, use the supplied mount to install your TomTom Rider in your vehicle. Read the instructions about positioning your device before you install your TomTom Rider.

If your box contains a car mount, install your TomTom Rider by doing the following:

1. Connect the supplied USB cable to the mount.

   Note: Use ONLY the USB cable supplied with your TomTom Rider. Other USB cables may not work.

2. Connect the USB cable to any of the USB sockets on the USB dual charger and plug this into the power supply on your dashboard.
3. Choose the best smooth location, on your windshield or side window, to mount your TomTom Rider.
4. Make sure that both the suction cup on the mount and your windscreen are clean and dry.
5. Press the suction cup of the mount firmly against your windscreen.
6. Turn the grip near the base of the mount in a clockwise direction until you feel it lock.
7. Place your TomTom Rider in the mount, making sure that it clicks into place.

   Tip: With the High-Speed Dual Charger you can charge your TomTom Rider and smartphone at the same time.