2D/3D settings

Tap this button to set the default view of the map. To switch between 2D and 3D views while driving, tap the left side of the status bar in the Driving View.

It is sometimes easier to view the map from above, such as when navigating a complex road network.

The 2D view shows a two dimensional view of the map as though viewed from above.

The 3D view shows a three dimensional view of the map as though you are driving through the landscape.

The following buttons are available:

• In 2D view: rotate map in direction of travel - tap this button so the map is rotated automatically with the direction you are travelling always at the top.
• Switch to 3D view when following a route - tap this button to show the map automatically in 3D view when you are following a route.