Switching on camping POIs

Your TomTom GO Camper comes with camping-related places of interest (POIs) pre-installed. They are switched off by default so you need to switch them on.

You can choose from camping POIs from ADAC Stellplatzführer and Campingführer, ANWB or Campercontact.

Note: Third-party POIs from ADAC Stellplatzführer and Campingführer, ANWB and Campercontact are only available for certain countries within Europe and are not available in Australia, New Zealand, North America or Canada.

Showing camping POIs on the map

1. Select Appearance in the Settings menu.
2. Select Show POI lists on map.

   You see a list of all the POI lists stored on your TomTom GO Camper.

3. Select the POI list that you always want to see on your map, for example, ADAC Stellplatzführer and Campingführer.

   You see a symbol for your POI list like those shown below:

   

4. Return to the map view.
5. Switch off your TomTom GO Camper completely, then switch it on again.

   Your POIs for camping and RV campsite locations are shown on the map.

   

   Tip: Tap a POI to plan a route to it.

Remove camping POIs from the map

1. Select Appearance in the Settings menu.
2. Select Show POI lists on map.

   You see a list of all the POI lists stored on your TomTom GO Camper.

3. Select the POI list that you want to remove from your map.
4. Select Do not show.
5. Return to the map view.
6. Switch off your TomTom GO Camper completely, then switch it on again.

   Your POI list locations have been removed from the map.