Use the Dock to install your Blue&Me-TomTom 2 navigation device inside the car.
To attach the Dock, insert the base of the dock into the dash plug on the car dashboard or A-pillar.
To insert your navigation device into the dock, push the two small buttons on the bottom of the dock to open the top bracket. Place the bottom of the device into the dock and then push the top bracket of the dock down until it clicks into place.
To adjust the position of the device, unscrew the knob on the back of the device to adjust the position using the ball joint and secure it by tightening the knob.
To remove the navigation device, press the two small buttons on the bottom of the dock and lift the navigation device out.
To release the dock from the dashboard, push the lower button on each side of the shaft and pull out the dock.