The guidance view

The guidance view is used to guide you along the route to your destination. The guidance view is shown when you start driving. You see your current location and details along your route, including 3D buildings in some cities.

Note: 3D buildings in guidance view are not available on all devices.

The guidance view is normally in 3D. To show a 2D map with the map moving in your direction of travel, change the 2D and 3D default settings.

Tip: When you have planned a route and the 3D guidance view is shown, select the switch view button to change to the map view and use the interactive features.

When your GO starts after sleeping and you have a route planned, you are shown the guidance view with your current location.

  1. Switch view button. Select the switch view button to change between the map view and the guidance view. When in guidance view, if you are driving, the small arrow rotates to indicate your direction of travel relative to north, with north being up.
  2. Zoom buttons. Select the zoom buttons to zoom in and out.

    Tip: On some devices you can also pinch to zoom in and out.

  3. Instruction panel. This panel shows the following information:

    Note: Select the instruction panel to see a list of turn-by-turn text instructions for your planned route.

  4. Route symbols. Symbols are used on your route to show your starting location, your stops (Adding a stop to your route from the current route menu, Adding a stop to your route using the map), and your destination.
  5. Main Menu button. Select the button to show the Main Menu.
  6. Speed panel. This panel shows the following information:
  7. Current location. This symbol shows your current location. Select the symbol or the speed panel to open the quick menu.

    Note: If your GO cannot find your location the symbol appears grey.

  8. Route bar. The route bar is shown when you have planned a route.

    Important: To see a wider route bar showing additional route information, change the setting for Route Information.