Pairing and connection

Your Blue&Me-TomTom 2 LIVE navigation device and Blue&Me in your car communicate with each other using a Bluetooth connection.

To pair your navigation device with Blue&Me, do the following:

1. Turn your car key to the MAR position.
2. Press the MAIN button on your steering wheel to open the main menu of Blue&Me in the cluster display of your car.
3. Use the arrow buttons on the steering wheel to navigate to the settings menu.
4. Select Settings and then Pairing/User Pairing.

   A 4-digit PIN code appears on the cluster display. You use this PIN in a later step.

5. Tap the screen on your navigation device to show the Main Menu.

   

6. Tap Find Blue&Me.
7. Tap Yes when asked if you want to start searching for Blue&Me now.
8. Enter the Blue&Me PIN on your navigation device. This is the PIN shown earlier in the cluster display of your car.

   A message confirming that the connection is successful appears both on the navigation device and in the cluster display. Each time the Blue&Me-TomTom 2 device is connected or disconnected from Blue&Me, you see a confirmation message.

When your navigation device and your car have been paired, the Car Menu button appears in the Main Menu of the navigation device.

From the Car Menu, you can access the functions specific to your Blue&Me-TomTom 2. The Car Menu button changes depending on the model of your car, and is updated whenever you connect your device with a new car.

In future, the connection is activated automatically each time the navigation device is switched on and either the car key is in MAR position or the car engine is running.

In some instances, you may need to repeat the pairing procedure. Note that the PIN code will change every time.To connect your Blue&Me-TomTom 2 device to a different car, you need to carry out the complete pairing and connection procedure.

Note: If a connection problem occurs, tap Settings on the device. Then tap Reset factory settings and repeat the pairing procedure.