Mounting on a motorcycle

Important: TomTom and RAM assume no responsibility or liability in connection to damages suffered due to modifications, improper installation, road hazards or accidents. Neither RAM nor TomTom shall be liable for any loss or damage, direct, indirect or consequential, arising out of the improper installation, or inability to use and/or mount the product. Before use, the user shall determine the suitability of the product for its intended use. The user assumes all risk and liability, as far as permitted by law, in connection with the mounting of the product.

Attach the RAM™ mount kit to your motorcycle.
Fix the holder to the mount and connect the wires to your motorcycle's wiring system.

Important: The red POS (+) contact needs to be connected to the motorcycle's wiring loom at a point between the ignition and the +12V battery supply. The black NEG (-) wire needs to be connected to the motorcycle's wiring loom at a point between the ignition and the -(GND) battery supply. Attach to a 12V point that can be switched off by the ignition such as the light circuit.

When you are attaching the mount kit to your motorcycle, follow these guidelines:
- If you are unsure about attaching the mount kit yourself, ask a professional to fit it for you.
- If you choose to attach the mount kit yourself, note that the Active Dock has a built-in fuse. This means that you don’t need to add a fuse between the device and the motorcycle battery.
- Make sure that the mount kit does not interfere with any of the controls on the motorcycle.
- Always use the correct tools. If you use unsuitable tools, you may damage or break the mount kit.
- Do not overtighten nuts and screws. You may crack parts of the mount kit or damage your handlebars if you overtighten nuts or screws.
- If you are using the u-bolt, don’t forget to put the rubber caps provided over the exposed threads.
Place your TomTom Rider in the holder.
You can rotate your device by ninety degrees to get your preferred view.